Fibre Glass Cutting By Using Abrasive Jet Machining and Analysis of Process Parameters
| ||International Journal of Computer Trends and Technology (IJCTT)|| |
|© - July Issue 2013 by IJCTT Journal|
|Volume-4 Issue-7 |
|Year of Publication : 2013|
|Authors :F. Anand Raju, V. Gnana Prakash, Dr. M.L.S Deva Kumar|
F. Anand Raju, K. Bharat kumar "Fibre Glass Cutting By Using Abrasive Jet Machining and Analysis of Process Parameters "International Journal of Computer Trends and Technology (IJCTT),V4(7):2274-2278 July Issue 2013 .ISSN 2231-2803.www.ijcttjournal.org. Published by Seventh Sense Research Group.
Abstract:- — Cutting of brittle materials like glass and ceramics by conventional machining is difficult than un conventional machining process .In this, an Abrasive jet machining is one of the best method to cut such materials. An abrasive jet machining is a jet of air which contains abrasive material. in AJM ,a high speed jet of air exits through a nozzle and the abrasive material is injected in the steam of jet. The purpose of the abrasive jet maching to perform machining or finishing operation such as cutting, deburring etc the cutting proceses is based on the principle of erosion of the material by impact of small abrasive particals with high stream of jet An attempt is made on cutting of, fiber glass to provide the information on the related parameters such as stand –off-distance and MRR by using Mat lab.
 HIGH RESOLUTION POWDER BLAST MICROMACHINING Henk Wensink, J.W. Berenschot, Henri V. Jansen, Miko C. Elwenspoek MESA’ Research Institute, University of Twente, P.O.Box 217, 7500 AE Enschede, January 2009.
 Micro fabrication of High-Aspect Ratio and Complex Monolithic Structures in Glass Eric Belloy, Anne-Gabrielle Paw lows ki, Abdeljalil Sayah, and Martin A. M. Gijs January 2009.
 Micro fluidic Chip Fabrication by Micro-powder Blasting Yung-Hsun Shih1,2, Yung-Kang Shen*,3, Yi Lin4, Keng-Liang Ou5, Rong-Hong Hong6 and Sung-Chih Hsu7 december 2008.
 Micro fluidic Chip Fabrication by Micro-powder Blasting Yung-Hsun Shih, Yung-Kang Shen, Yi Lin, Keng-Liang Ou, Rong-Hong Hong and Sung-Chih Hsu7 2008.
 ABRASIVE JET MACHINING FOR EDGE GENERATION Matthew W. Chastagner and Albert J. Shih Mechanical Engineering University of Michigan Ann Arbor, Michigan 2007
 Micromachining of Glass Inertial Sensors Eric Belloy, Abdeljalil Sayah, and Martin A. M. Gijs 2000.
 Development of a magnetic abrasive jet machining system for precision internal polishing of circular tubes Jeong-Du Kim *, Youn-Hee Kang, Young-Han Bae, Su-Won Lee Received 3 April 1996..
Keywords : — Composites, CATIA, vacuum bagging process, UAV.